Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
Flutch stuck to floor no leaks.
You could damage the clutch the clutch fork or the transmission.
The most common reason to have a clutch pedal that goes all the way to the floor is a broken clutch cable this is extremely common particularly on older cars.
No leaking or anything.
Check underneath your vehicle for any pools of liquid and check the engine bay too.
I work by myself.
It started drove awhile then repeated the problem.
Part 1 of 4.
Mechanical failure linkage pedal breaks pressure plate breaks clutch fork breaks or becomes detached or hydraulic failure the hose ruptures one of the cylinders fail or the fluid level drops below the pickup level.
Could it be something with the clutch pressureplate flywheel.
So i was trying to two man method to bleed it myself.
If there are no fluid leaks at the master cylinder no swirl or bubbles in the clutch reservoir and the clutch pedal does not slowly descend with constant pressure then the master cylinder is likely working.
Ok so everything has been fine.
Floor or engine bay leaks.
Trying to narrow it down before i have to pull the trans out.
Replaced master cylinder 2 months ago and slave cylinder is new too a yr ago.
I hand pumped my clutch for about three hours straight.
At home i pulled the clutch pedal back up by hand started it up in neutral pushed the clutch pedal in put it in reverse it went in and immediately the clutch started to engauge pushed clutch in and it stuck to floor again.
I was told to put a tube i used 1 4 line.
All of a sudden clutch pedal fell to floor no pressure.
Verify all lines between are not leaking.
Replacing the cable will allow you to engage the clutch and change gears once more.
Common reasons for this to happen.
Diagnosing a clutch pedal on the floor due to failed release bearing.
Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
Seems like it has no compression fixing the clutch i bet one of the lines had been leaking clutch fluid for quite a while.
You could damage the clutch the clutch fork or the transmission.
Obviously my clutch is bleeding down.
No fluid leaks visible at slave cyl or lines.
Everything seems intact still.
And pump the hell out of the clutch.
Still have full fluid.
Verify that your clutch slave cylinder it will be mounted on the transmission is not leaking.
There s only two ways the pedal can go to the floor.
If your car s clutch slave cylinder is failing you can also expect to see some visible leaks.
Preparing the vehicle to check the clutch pedal for a failed release bearing.
Still no pressure in clutch.
My 1991 rx7 s clutch went so loose that it actually stuck to the floor and the car died.
To my bleeder valve on slave cylinder and put the other end in my master cylinder reservoir.
